DIN-DALI-2 is a DALI interface for Crestron systems providing control of up to 2 individual DALI loops. Housed in a DIN-rail enclosure, the DIN-DALI-2 is a great low-profile Cresnet® or Ethernet companion to the DIN-AP2 processor, or any 2-Series control system. In addition to controlling the DALI data bus, it includes an integrated DALI power supply. The single-wire connectivity simplifies both new and retrofit installations, and Power-over-Ethernet (PoE) versatility assists in situations with existing CAT5 infrastructure.
Interfaces with 2 independent DALI loops
Controls up to 128 DALI ballasts
Cresnet or PoE communication for single wire installation
Integrated DALI power supply
Crestron DALI commissioning tool for easy setup
Override input
9M wide DIN rail mounting
Spec Sheet available - Yes
Operating Temperature (Maximum):
104 F
Operating Temperature (Minimum):
32 F
Depth:
2.28 in
Height:
3.71 in
Width:
6.26 in
Product Weight:
0.59 lbs
NET Connector:
(2) 4-pin 3.5mm detachable terminal blocks, paralleled, Cresnet slave port
OVERRIDE Connector:
(2) 2-pin 3.5mm detachable terminal blocks, paralleled, Sensing input for external low-voltage contact closure, Activates override mode when a closure is present, forces each ballast into its defined "System Failure Level", Minimum Closure Rating: 10mA (per module) at 24 Volts
PWR Indicator:
(1) Green LED, illuminates when DC power is applied to the NET port
NET Indicator:
(1) Yellow LED, indicates communication with the control processor
PoE Power Usage:
IEEE 802.3af (802.3at Type 1) Class 0 PoE Powered Device, capable of powering up to 128 DALI ballast controllers
Cresnet Power Usage:
9 watts (0.375 Amps @ 24 Volts DC), DALI POWER switch set to "INT", 2 Watts (0.08 Amps @ 24 Volts DC), DALI POWER switch set to "EXT", capable of powering up to 128 DALI ballast controllers
The Premier team has been stellar and attentive to every single need we have had and were on site during the entire construction of our home to insure first class install and service.